3D NLS analyzer hardware installation instructions
3D hardware installation instructions:
1.Connect the data cable to the computer (for the square on the device data line interface), The green plug Headphone insert into the Headphone jack(Close to the data line interface round jack)
;
the red plug Headphone insert into the the data jack(outer circle jack)..
2.Open the device (the first time, to wait for the computer to recognize the device and automatically install the driver before using the device)
3.Computer resolution must be set to 1024 x 768
3.Run the 3D software “Diacom-NLS old”
4.After entering the software, select the sensitivity as 70% ,on the third button of the initial page is to set corresponds language.
